*1 The length of printing or cutting is subject to the limitations of the program.
*2 Using Roland specified media, print travel of 1m, temperature: 25°C, humidity: 50%RH
*3 Not assured when the print heater or dryer is used.
*4 Using Roland specified media, loaded on the shaft, [PREFEED] menu item must be set to “ENABLE,” with 25mm or more for both right and
left margins and 35mm or more front margin, excluding expansion or contraction of the media.
*5 Provided that media length is under 3000 mm. Temperature: 25°C
Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*6 Using Roland specified media, data size: 1000 mm in the media-feed direction, 1346cm in the carriage-movement direction.
No lamination. Automatic detection of crop marks at 4 points when media is reloaded.
During cutting, [PREFEED] menu item must be set to “ENABLE.” Temperature: 25°C
Excludes the influence of misalignment, expansion or contraction of the media.
*7 Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
The preset temperature may fail to be reached. Depending on the ambient temperature and media width.